NAVIS NavDP 4000. Operation Manual
System
— the control system will be switched off;
Return
— return to the Starter.
Simulator Mode
Select
Simulator Mode
to start the operation in the
Simulator Mode
(see Section 11, page 245 for details).
Service Mode
See Section I, page 341 for details on
Services
menu.
The following submodes are available:
Monitor
The Monitor utility starts. This utility displays information about data flow between CC and PLC. The submode
is intended for the system calibration while DST is in process. It is password protected.
PLC Faults
Alarm Viewer
Alarm listing.
COM Ports
COM port data viwer.
Info
Display version and other information about the system
Figure 3.5: Service menu listing
If you select
Real Mode
, the control system gets ready to take control over the thrusters, and immediately checking
the interfaces with the sensors, position reference systems and thrusters. The Operator Interface Screen appears on the
monitor.
Note that, although the control system is switched on, it does not have control over the thrusters unless the Mode
Selector is set to due position (see Section 2.1.4, page 22) for taking control: IJ position for the IJ control system, and
DP position for the DP control system.
Software Versions
To display a version of the system software select the
Info
item in the
Service
menu.
Following view will appear
(Figure 3.6). To display a detailed information about version of the system software select the
Details
item. Following
view will appear (Figure 3.7).
53
Doc. 000.JDP-10000-OME, rev.3.3.13/“2102.$–17A-Advanced”
Содержание NavDP 4000 Series
Страница 88: ...NAVIS NavDP 4000 Operation Manual Figure 5 35 Dark Theme 87 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 222: ...NAVIS NavDP 4000 Operation Manual Figure 10 74 Drift Plot Window 221 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
Страница 324: ...NAVIS NavDP 4000 Operation Manual Figure H 4 Remote DLS Mode 323 Doc 000 JDP 10000 OME rev 3 3 13 2102 17A Advanced...
