NAVIOP Loop S, Руководство пользователя

Страница: 5 / 27

| 5
Introduction | Loop S User Manual
Introduction
Introduction to the system
The Loop system is used to monitor and control electrical equipment. When connected to
a compatible MFD (Multiple Function Display), the MFD can be used to operate the Loop
system.
!
Warning:
The Loop system should only be used to aid navigation. In no
way can this system replace the experience and awareness of the captain
who bears sole responsibility for safety during navigation. The operation of
equipment or devices installed on the boat does not depend on the status
of the Loop system. If the supervision system is switched off or there are
communication errors between the system and the equipment it monitors,
all bypassed relays can be controlled manually.
¼
Note:
For specific information on the operation of equipment that cannot be controlled by
the system, consult the specific technical documentation supplied by the manufacturer of
the equipment (not included in this manual).
System parts
A B
D
C
E
A
MFD (1 or more MFDs connected to the NMEA 2000 network)
B
NMEA 2000 network
C
AT30 protocol converter
D
Naviop CAN network
E
Egon+ board
¼ Note:
Maximum 2 Egon+ boards can be installed. Each board can control and monitor 8
relays and monitor 8 power outputs.
¼
Note:
Loop S is equipped with one Egon+ board. Loop S+ is equipped with two Egon+
boards.
1