Navig8r NAVSPORTPRO, Руководство пользователя

Страница: 6 / 17

6 | P a g e
CHARGING
Before using your NAVSPORTPRO, check whether the battery has sufficient charge. If the power
level is low, use the supplied USB cable to recharge the battery/s. Once connected, the red
indicator lamp will blink slowly. When fully charged the red indicator will be constantly on. A
full charge time takes approximately three hours.
During video recording, if the battery power runs low or the memory card is full, the system
saves the current file (if recording) displaying a prompt of “Low Battery” or “Card full” on the
LCD screen, before entering standby mode.
MOUNTING PRECAUTIONS
Waterproof Housing
The O-ring, lens cover and all other parts of the waterproof housing are not user replaceable.
Tampering with the case will void the warranty.
Avoid contact with chemical or other corrosive substances, such as strong acid’s or alkalis.
Do not subject the waterproof housing to temperatures over high (50°C) or lower than (-10°C)
for sustained periods of time
If the housing were to heat substantially, the case could warp and compromise the waterproof
seal.
Before use, ensure that the O-ring is intact, the seal is clean and particulate-free, the housing is
fully sealed, and the buckle is secured and tight.
After using the housing in sea water, wash it thoroughly with fresh water.
INSTALLING THE WATERPROOF HOUSING
The NAVSPORTPRO camera can be hand-held or used with hands-free accessories. It can be
installed anywhere or, after being equipped with a waterproof housing, taken underwater.
1. Assemble the TFT screen/ Battery onto the
video camera.
2. Put the NAVSPORTPRO camera into the
waterproof housing.
TFT screen /
Battery
Video camera
Assemble the
TFT screen
onto the
video camera
Video camera
Waterproof
housing
Put the video
camera into
the
waterproof
housing