Evaluation Board of ML8088s Receiver
Operating Manual 2.0
17
autonomous/differential operation mode;
noise level in GLONASS and GPS channels;
average and maximum GLONASS/GPS signal levels;
The status bar displays the serial port current settings (its number and speed).
The parameters controls are placed in several tabs.
Restart
Fig. 12. Navia G GPS application restart management window
This tab allows “Hot”, “Warm” and “Cold” module restart. For “Cold” restart you can
specify the sets of data which have to be cleared by the restart.
Besides, you can reset and restart the module. The TTTF parameter (Time To First Fix)
indicates the time elapsed from running the restart command until receiving the correct position
coordinates.
Data Output redirection
Fig.13. NAVIA G GPS application module data output window tab.
This tab provides module set-up by port and output speed selection for positioning system
data. For parameter activation additional module restart is required.
This tab also shows NMEA channel estimated load, which depends on exchange rate and
message set. Please note, that channel load is estimated approximately on special PSTM signal
group basis and the actual load may significantly differ from estimated.
Normal application and channel operation requires less than 70% channel load.