NAVI D-25, Инструкция по эксплуатации

Страница: 76 / 227

3 Functions
3.1 Data memory function
D-52/53/54/55 65
3
Functions
This chapter describes the various functions of the
meter.
3.1
Data memory function
The measured data can be stored automatically or
manually.
●
Auto data memory
You can automatically store the data at certain intervals
using this function. For the setting procedure, refer to
“3.4.5 Auto data storage setting” page 81
●
Data memory
In all measurement modes, you can store data when the
instantaneous value is measured or the measured value
is held (HOLD status) during the Auto HOLD
measurement by pressing the
▲
key.
The measurement reading is stored along with the
temperature, data, HOLD value/instantaneous value,
ATC/MTC, calibration point (only for pH and ION
measurement), and sample ID at the time the measure-
ment was taken.
After the data number is displayed, the screen returns to
the initial screeen. Up to 300 items of data can be stored
in the memory. If the number of data items exceeds the
maximum limit, ERR 10 is displayed and no more data
can be stored.