background image

 

LOCATION & REMOVAL 

With the head unit now removed locate the power ISO 
plug and the Black optical plug shown below. 

 

 

 

 

 

 

 

 

 

Insert OPTICAL leads into TOOKI-POR loom and car loom 
to create loop, see diagram below 

To remove the (out) fibre optic cable from the factory con-
nector you will need to remove the black outer casing and 
push out the blue locking insert. You will need to do the 
same to insert the cable into the supplied loom. (shown in 
previous fig) 

Next plug in the power link loom into the car harness, plug 
in the microphone (supplied) and insert optical plug into 
the interface. 

INSTALLATION 

Firstly to determine if your PCM unit is compatible, 
press and hold the MAIN & TRIP buttons to display 
the PCM Software version. Should be 2.0 or above 

Installation is made at the front unit. 

To remove the head unit you will need to remove the 
surrounding trim then the 4 screws securing the unit, as 
below. Some models are removed with specific radio 
keys. 

 

 

 

 

 

 

 

 

 

 

TOOKI-POR is designed to work with a radio that has a 
factory SIM card based GSM phone option rather than 
Bluetooth. As such, certain functions displayed on the 
radio are not supported by the TOOKI-POR. 

The factory phone module (if fitted) will need 
to be removed from its power and optical con-
nection (optical cables must be re-connected 
to continue loop) This module is located under 
the drivers (O/S) seat on all models. It is possi-
ble to install the TOOKI kit at the Factory 
phone location and allocate 12v+ perm and 
ground. 

 

INTERFACE

            

CAR CONNECTOR

    OUT cable from screen 

IN cable from interface 

1. Press TEL on PCM Radio. 

2. “Tooki Searching” indicates no phone connected. 

 

3. Start the pairing procedure on your mobile phone. 

Make sure the Bluetooth feature is turned on. Con-
sult your phone’s manual for phone-specific pairing 
procedures. 

 

4. Once your mobile phone discovers Tooki xxxx (last 
4 digits will vary)select and pair Tooki

 

5. When prompted for a passkey, enter 6888 on your-
mobile phone. 

 

6. Once pairing is complete, press TEL and select  
phonebook” Choose the phone you wish to pair, and 
select. After a short while you  should see your signal 
strength indicator and phone book list on the PCM Ra-
dio. Pressing “Tel” will then show you your network pro-
vider and signal strength.  

 

7. You may pair up to 5 different mobile phones. For 
information on phone selection, section 6 

 

8. To delete a paired phone select phone book, scroll to 

the phone name you wish to delete, select the name 
by pushing the rotary button. When the name is se-
lected scroll to “delete” on screen and you should 
see the message “are you sure you want to delete” 
select yes. 

9. you may use any of the units hard keys as well as 

the on screen lists to dial out.  

 

 

OPERATING INSTRUCTIONS 

Отзывы: