BHM
04/16/14
NTV-DOC175
rB2
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
4 |
P a g e
Note: Not all vehicles will have fiber optics equipped. NAV-TV can provide a fiber kit, contact tech support.
Radio Removal (997: 911, Boxster, Cayman)
1.
Before removing radio, confirm that the radio displays
‘CURRENT SYSTEM’ when you press ‘INFO’ & ‘SOURCE’
together
(if not, this kit is NOT compatible).
2.
Remove the Torx t27 screw on each carpeted panel that
sits in front of the leather side panels (on the sides of
the radio).
3.
Remove the now exposed (2x) Torx t20 screws on each
leather panel on each side of the factory radio.
4.
While sitting in the driver’s seat, pull each panel straight
towards you (or towards the rear of the vehicle) to expose
the sides of the radio.
5.
On each side of the radio, close to the front of the radio, there are (2x) Allen screws.
Turn each of these screws
counter clockwise
1/4 turn or until they stop
.
When all 4
screws have been turned, the radio will be free to pull straight out of the sub-dash.
6.
Remove radio, disconnect all plugs and set the radio aside.
SIR-PCM 3 Interface Installation (all vehicles)
1.
Remove the factory fiber connector from the
factory 44-pin plug by gently prying up on the
locking tab with a pick tool.
2.
Remove the provided
Fiber connector
from the
fiber cable
with a pick tool
.
3.
Connect the provided
Fiber cable
into the vehicle’s
MOST loop via the diagram below:
Factory MOST cable
Provided MOST cable
Before
After
Step 2
Step 1
