Chapter4. Receipt Printer (SPR60) Operator Manual
4-14
©
Nautilus Hyosung, Inc.
All Rights Reserved.
Troubleshooting and maintenance
► If errors occur in the printer, consult the troubleshooting table below. If still can’t settle the trouble,
please contact with Nautilus Hyosung or the distributor.
Errors and settlement
►
Error index
Errors
Description
Error LED
200m
s
Print head
overheating
Temperature of the print head is too high.
Abnormal voltage
Input voltage is too low or too high.
Cutter error/paper
jam
Cutter can’t work normally or Paper jams.
Print head uplifting
Print head is uplifted.
Paper end
Paper sensor detects paper end.
Calibration failure
Marked paper calibration error.
Paper near end
Paper sensor detects paper near end.
Macro definition
execution status
In the execution of a macro definition.
Normal stand-by
status
<Note!>
In the default configuration, the printer will not stop printing when paper end, and the user could
change the default configuration as stop printing when paper end via KIOSK Utility software, and under
the new configuration, the error LED will flash and indicate paper end;
Printer executes the following activities when errors occur:
- Stop printing;
- Busy signal is available;
- Error LED flashes;
Содержание MONiMAX8200QTN
Страница 1: ...Operator Manual MONiMAX8200QTN System V01 00 00 2017 09 08 Nautilus Hyosung Inc All Rights Reserved...
Страница 21: ...Operator Manual Chapter2 Introduction Nautilus Hyosung Inc All Rights Reserved 2 11 Basic Specification...
Страница 23: ...Operator Manual Chapter2 Introduction Nautilus Hyosung Inc All Rights Reserved 2 13 Basic Specification...
Страница 59: ...Chapter4 Receipt Printer SPR60 Operator Manual 4 18 Nautilus Hyosung Inc All Rights Reserved...