Service Manual Chapter7. Cash Dispenser Unit
© 2013
Nautilus Hyosung Inc.
All Rights Reserved.
7-52
Lubrication
► Lubrication
1. Check the oiling status before running or storing it. In case there is any part lack of
lubricant, apply lubricant to the corresponding part in compliance with oiling
standard.
2. Apply grease only if necessary during the regular field inspection. In case there is
enough lubricant, do not apply additional lubricant. However, if lubricant is
contaminated, remove alien substances from lubricant before applying it to the
machine.
3. All pivot points and frictions parts must be oiled.
4. All points except the following must be oiled:
Printing head, Magnetic head, Package, Micro switch contact, Drive roller, Timing
pulley, and Timing belt
5. All oiling operations must be based on oil drop unit. However, when contact
between the oiling device and the oiling target is not avoidable, the contact time must
not exceed one second.
<Note!>
1. Lubricant must not leak. In other words, lubricant must be applied only to the parts
that need oiling. Do not apply excessive lubricant. Lubricant must not contaminate
other parts. Be
careful
that
the micro switch, the sensor, the timing pulley, the
timing belt, the package, the printing head, and the magnetic head are protected
from lubricant.
2. Do not clean plastic parts or protection devices with alcohol and other agents than
the designated one.
3. Remove dust, oil, and grease from the machine, and clean the machine with dry soft
cloth.
4. Be careful that the paper contact part in the paper path is protected from lubricant.
5. Table of Oiling Standard
<Note!>
Y1: Once a year.
NO.
LOCATION
LUBRICANTS
INTERVAL
REMARK
1
Tension Pulley
Mobil (1)
Y1
Lubricate the friction part
between shaft and pulley
2
Gear support gear
teeth surface
AlbaniaGreaseEP1
Initial
Oiling
-
3
Gate spring hook
AlbaniaGreaseEP1
Initial
Oiling
-
4
Gear support spring
hook
AlbaniaGreaseEP1
Initial
Oiling
-
5
Pick-up Module gear
teeth surface
AlbaniaGreaseEP1
Initial
Oiling
-
