Current as of 2022-05-23
M67 Mounting Ring
Instruction Manual
Mounting Ring for 86221
PN# 86223
F
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the requirements of
professional as well as amateur underwater photographers and fulfill them
through the innovative designs of our products. We strive to achieve a high level
of user-friendliness by allowing stress-free installation and easy operation of all
important functions of the camera.
Please read this manual carefully before using the product, this will maximize its
performance as well as its lifetime.
W
ARRANTY
All NAUTICAM Products are warranted against any material and manufacturing
defects for two years from the date of purchase for consumer use.
This warranty
only applies to products purchased from authorized NAUTICAM dealers and does
not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service center(s). Please note that this warranty only applies when the product
is purchased in the territory where the service center is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability to
capture images even if it is due to the malfunctioning of our products.
Unauthorized modifications and/or repairs of our products will automatically
invalidate the warranty.
P
ACKAGE
C
ONTENTS
M67 Mounting Ring for 86221
Thumb Screws x 8
C
HANGE THE
M
OUNTING
R
ING ON THE
MWL-1
A M67 mounting ring is supplied for MWL-1 to use on the dedicated two flip
holder products.
Please follow below instruction to exchange the Bayonet Mounting Ring of MWL-
1 to M67 Mounting Ring.
Unscrew the eight thumb screws, and remove them from the back of the lens.
Remove the bayonet mounting ring of MWL-1, and keep the 4pcs black
cylindrical positioning pins in position.
Locate the 4x sockets on the M67 mounting ring as shown, align with the
positioning pins on the MWL-1 and install accordingly.
I
DENTIFICATION OF
P
ARTS
Thumb Screws (x8)
