Nautel VS2.5, Руководство по установке

Страница: 34 / 56

VS2.5 Installation Manual Commissioning
Page 8-6 Issue 11.0 2019-05-10
Going On-Air
Important:
Before going on the air, if you want the safety interlocks to operate properly, the
shorting jumper installed in “Pre-Commissioning” on page 8-2 , Step 3 should be removed.
1. Switch off the ac power using the
POWER
switch on the rear of the VS2.5.
2. Connect the transmitter's RF output to an antenna system.
3. Switch on the ac power using the
POWER
switch on the rear of the VS2.5.
4. Use the front panel display to begin transmitter operations. For detailed instructions,
refer to the VS2.5 Operation and Maintenance Manual.
WARNING:
If a jumper is placed between external interlock pins 19 and 20 of the
REMOTE I/O-A (A1J2A)
connector on the rear of the VS2.5, safety features
controlled by the external interlocks will be disabled. A fail safe
method of alerting personnel to this fact should be implemented.
Voltages which are dangerous to life will be present on the RF output
stages and the antenna system if the transmitter is turned on.
WARNING:
If you are not planning to use DHCP (i.e., your network does not have a
DHCP server or you are connecting directly to a laptop) users should
set DHCP to OFF. This action will remove the alarm: ARM Network
Down. This action can be completed via the following path from the
front UI panel path: User Settings -> Network Setting -> DHCP.