Nautel VS2.5, Руководство по установке

Страница: 13 / 56

VS2.5 Installation Manual Connecting to station reference ground
Issue 11.0 2019-05-10 Page 3-1
Section 3: Connecting to station reference
ground
To connect to the station reference ground, perform the following steps:
See Figure 3.1 on page 3-2 as an installation guide.
1. Locate the VS2.5’s safety ground stud (E1) on the rear panel of the VS2.5.
2. Attach a continuous, low impedance copper conductor (minimum 3/4” braid) between
the station reference ground and safety ground stud E1. Ensure the station reference
ground conductor is at least 3 mm (1/8 in) from the exterior of the transmitter or host
cabinet.
3. For information about grounding the lightning protection, see the VS2.5 Pre-
Installation Manual.
For detailed information about lightning protection, see the Recommendations for
Transmitter Site Preparation manual, available from your Nautel sales agent, or online
from the Nautel website.
4. Firmly tighten all hardware.
Note:
The VS2.5 Quick Start Guide provides a more streamlined method to unpack,
install and commission your transmitter. If you used the Quick Start Guide to
successfully commission your transmitter, Nautel recommends you use the
information in this Installation Manual to verify your installation or for more in-
depth information, as required.
CAUTION:
It is important that the conductor attached to E1 does not contact the transmitter
chassis or host cabinet at any other point.