Nautel NV30LT-N, Руководство по эксплуатации и техническому обслуживанию

Страница: 118 / 226

NV30LT-N OPERATIONS & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.100 VERSION 0.1 2015-03-01
SNMP Configuration
The SNMP configuration page (see Figure 3.2.83 ) provides a means to configure the SNMP agent and
associated traps.
Figure 3.2.83: SNMP Configuration page - Agent tab shown
Agent Settings
Using the
Agent
tab (see Figure 3.2.83 ), you can configure the SNMP agent as follows:
1. Enter the five fields, noting the following:

Agent Port
: Enter the UDP port where the SNMP agent checks for requests. The default
setting is 161. If your transmitter is behind a firewall, you must open this port to use SNMP.
 Read Community : Enter the password for the SNMP client application to allow acquisition of
channel values. Provide confirmation of this password in the
Confirm
field.

Write Community
: Enter the password for the SNMP client application to allow changing of
channel values. Provide confirmation of this password in the Confirm field.
2. Click the Enable Traps check box to allow the SNMP agent to send trap notifications (see Traps
Settings on page 3.2.101 ). Enter the two additional fields as follows: