Nautel GV20, Руководство по установке

Страница: 39 / 66

GV20/GV15 INSTALLATION MANUAL INSTALLING CONTROL/MONITOR WIRING
VERSION 5.0 2021-03-01 PAGE 2.8.3
7. Connect the appropriate control/monitor cable(s) to the connector(s) described in Section 1.8 of
the GV20/GV15 Pre-installation Manual.
 For connection to the remote interface PWB (A16), route the control/monitor cables to the top
edge of the remote interface PWB. Strip a small amount of wire from the end of each wire and
connect the control/monitor cables to the appropriate terminals of the
CUSTOMER ALARM/
STATUS (TB2) and CUSTOMER CONTROL (TB3) terminal blocks.
 For connection to the controller (A4), route the control/monitor cables to the rear of the
controller. The transmitter’s ancillary kit contains male (Nautel Part # JS31) and female (Nautel
Part # JS28) 25-pin D-sub connectors and connector shells (Nautel Part # JS35) to facilitate
connections to the
REMOTE I/O-A (A1J2A) and REMOTE I/O-B (A1J2B) 25-pin D-sub
connectors.
8. For the transmitter’s external interlock control, route a shielded cable to one of the following
locations:
 For connection to the remote interface PWB (A16), connect the shielded cable to TB1,
between
INTLK terminals 1 and 2 (see Figure 2.8.2 on page 2.8.4 ) or between terminals 19
and 20 on the CUSTOMER CONTROL terminal block (TB3). Use one option only; do not use
both.
 For connection to the controller (A4), connect the shielded cable to pins 19 and 20 on the
REMOTE I/O-A 25-pin male D-sub connector (A1J2A) on the rear panel of the controller.
9. For web based control of the transmitter, route an Ethernet (shielded Cat5) cable to the right-hand
edge of the remote interface PWB (A16). Connect the Ethernet cable to the
LAN connector (J1)
(see Figure 2.8.2 on page 2.8.4 ).
10. Re-install the rear filter panel, removed in Section 2.2, using its 16 1/4-turn latches (see
Figure 2.2.1 on page 2.2.3 ).