Nautel Exporter Plus, Техническое руководство по эксплуатации, Страница: 31 / 186

Exporter Plus Technical Instruction Manual Connecting the Exporter Plus
Issue 1.0 2020-05-05 Page 5-1
Section 5: Connecting the Exporter Plus
This section describes the interconnection between the Exporter Plus, user-supplied audio
processor(s), and UPS. Typical configurations are illustrated at the end of this section:
• Figure 5.2: Exporter Plus Connections - FM system
• Figure 5.3: Exporter Plus Connections - AM system (NX series)
• Figure 5.4: Exporter Plus Connections - AM system (XR, XL, NA series and J1000)
It is assumed that there will be user-supplied audio processing, on both the IBOC and Analog
MPS Audio.
Make the following connections, also shown in the applicable Figure 5.2 (on page 5-3), 5.3 (on
page 5-4) or 5.4 (on page 5-5).
•
Ac and UPS Power Connections
Use standard 120 V ac 60 Hz line cords. One line cord (Nautel Part # JN25) is provided
with the Exporter Plus.
•
Exporter Plus Audio Input Connections
Use the XLR cables labeled W1 (digital) and W2 (analog), provided in the ancillary kit,
to connect the audio processor output feeds to the Exporter Plus.
•
Exciter Link Ethernet Connection
Use the CAT5 Ethernet cable labeled W4, provided in the ancillary kit.
•
Exporter Plus Analog Output Connection
Use the XLR cable labeled W3, provided in the ancillary kit, to connect the Exporter
Plus’ analog out to the system exciter.
•
10 MHz Connection
For FM systems only (if used): use the BNC cable labeled W6, provided in the ancillary
kit, to connect the Exporter Plus’ 10 MHz output to the system exciter, as applicable.
•
GPS Antenna
Obtain the GPS antenna (Nautel Part # UD63) and GPS cable (Nautel Part # 198-5508
or Nautel Part # 198-3305-01) from the ancillary kit.
•
Remote Interface
Use the DB25
STATION INTERFACE
connector to connect remote inputs and outputs to
the Exporter Plus (see Section 7, “Remote interfacing” on page 7-1 for remote connec-
tion details).