natus ICS Aircal, Руководство пользователя

Страница: 13 / 38

13 ICS Aircal
ICS Aircal Front Panel
If the temperature does not reach 12°C in approximately 3 minutes, repeat steps 1 through 9 .
Turn off the device and unplug from the electrical wall outlet.
Check if the water reservoir is full. If not, place the funnel in the refill hole of the reservoir and add additional water.
Remove the funnel and replace the internal cover. Tighten the screws to secure.
Replace the external cover and tighten screws to secure.
Plug the power cable of the device into the electrical wall outlet and turn it on.
2.2.3.6 Water removal procedure
Turn the ICS Aircal device off and unplug it from the electrical wall outlet.
Wipe off any dust on the top of the ICS Aircal device prior to opening the case to refill the reservoir.
Face the front panel. On the back right side is a small cover. Using the Allen key (supplied with the cradle), unscrew
the exterior cover and remove.
Using the Allen key unscrew the internal cover and remove.
Using the syringe kit provided, remove the water from the reservoir. Replace both covers after the water is
removed.
3 ICS Aircal Front Panel
This section describes all operational controls located on the front panel of the ICS Aircal device.
3.1 ICS Aircal device on/off
This switch is a push on/push off switch on the bottom left of the front panel that turns the ICS Aircal device on and
off. The device is on when the green LED and the digital display turn on. When the ICS Aircal device is turned on, it is
in operation mode.
3.2 Standby/Operation mode
When the ICS Aircal device is turned on, the default mode is airflow on. Pressing the airflow button switches
the ICS Aircal device between standby mode and operation mode. In standby mode (airflow off), the irrigator is on,
but the airflow, water and air pump, fan, and warming and cooling mechanisms are off. Standby mode is
recommended when the ICS Aircal device is connected to an ICS VNG/ENG and the foot switch is used for starting
other tests (e.g., Dix Hallpike) in the ICS Chartr software. Turn off the airflow when the device is not in use.