natus Dantec Keypoint G4, Инструкции по эксплуатации оборудования

Страница: 29 / 42

Hardware Instructions for Use
29
Advanced Stimulation Handgrip (optional)
(1) Output Electrode Pins
For direct stimulation on the skin, see the description of the stimulation electrodes in this section.
(2) Polarity and Stimulation Indicators
The stimulation cathode is indicated by a constant green light (LED). During stimulation, the other LED
indicator will flash yellow –once for single stimulation and intermittently for repetitive stimulation. Note that if
the stimulator is not enabled, no LEDs will light.
(3) Single Stimulation Button
Shortly press the button on the handle.
(3) Repetitive Stimulation Button
Press and hold down the button on the handle for at least 1 second.
Stop
To stop the repetitive stimulation, press the Repetitive Stimulation button again.
(4) Stimulation Intensity Control Wheel
To increase or decrease the current intensity, rotate the wheel.
Alternatively, you can also use the mouse wheel or the Stimulation Intensity control knob on the control panel.
Reset
To reset the intensity to its zero level, press the Reset Stimulation Intensity key on the control panel.
(5) Button A: New Site Button – Active in Motor and Sensory Nerve testing
Shortly press the button on the handle.
(5) Button A: Clear – Active in F wave
Shortly press the button on the handle.
(5) Button A: Run Train – Active in RNS
Shortly press the button on the handle.
(5) Button A: Next Test – Active in Motor, Sensory, F wave and H Reflex
Press and hold down the button on the handle for at least 2 seconds.