Assembly Instructions
1.
Lamp Unit Installation
x
Use the
‘U’ shaped mounting plate located to the rear of the lamp to mark where yo
u want
to install the lamp.
Make sure it is clear of obstacles such as cables and electric lines.
Secure lamp to the wall with the screws provided.
Carefully route the wire from the solar panel to the lamp and plug it into the battery
housing input.
x
Adjust the motion sensor so that it faces the area where motion detection is desired. You
can move it up and down by adjusting the screw on the neck of the motion detector.
Note:
The lamp unit should be mounted 6.5-9 feet (2-3 meters), from the ground to ensure motion
detection is optimized.
2.
Wall or deck mounting of solar panel
x
Secure the bracket to the solar panel with the screw provided (shown below).
x
Set the bracket on the surface and secure in place with larger screws provided.
x
Adjust the angle of the solar panel to ensure it receives optimum sunlight.
Note:
The Solar Panel is equipped with a length of wire. Ensure that the wire will reach the desired
position of the lamp before making the final installation.
Before Each Use
Solar lights require sunlight to function properly. Extended periods of cloudy weather will cause
shorter runtimes. Shade on the solar panel is to be avoided. The solar panel may be cleaned with a
clean damp cloth. Do not use soap, solvents, or abrasives.
A regular visual inspection is
recommended. Ensure the solar panel is free from debris and in a location where it will receive
several hours of sunlight each day. Ensure the light is facing the desired direction and that there are
no nearby alternate light sources that may interfere with the motion sensor.
Page
4
of
16
