Native Instruments Maschine, Справочное руководство

Страница: 199 / 245

MASCHINE 1.5 Reference Manual – 199
11.2.2 Editing a Sample (Software)
In the Edit Tab, you can do the following: adjust Start and End of the Sample, enable Loop
Mode, adjust Start and End Points of the Loop, or set a Crossfade between the End and the
Start point of the Loop.
The Edit Tab on the software
1 Start and End of the Sample
Adjust the Start and End point by either dragging the small grey icons labeled “S” (for Start)
and “E” (for End) left and right using the mouse, or by entering the Start and End points in
their respective fields.
2 Loop Settings
Here you can define a Loop by clicking on the Loop Button. The Loop will be repeated as
long as the note is triggered, which can be useful to loop a whole Sample or part of it in order
to simulate a longer tone. The Start and End point can be edited by entering the Start and
End points in their respective fields. Alternatively you can also alter the Start and End of the
Loop by dragging the handles of the Loop and move the entire Loop by dragging its title bar.
Crossfade allows you to define a crossfade value between the end and the start of the Loop.