![background image](http://html1.mh-extra.com/html/national/all-day-battery-ride-on-7700/all-day-battery-ride-on-7700_instruction-manual_3373489045.webp)
Page 45
7700 MACHINE MAINTENANCE
DUAL SLIDE PLATE
TO REMOVE SLIDE PLATE
1. Lower the slide plate to the floor and place a block under the assembly.
2. Remove the front cylinder by taking out the 1/2” bolt out of the bottom and removing the pin from the top of the
cylinder.
3. Remove E-clips from the pin at the bottom of the internal cylinder then remove the pin.
4. Remove the pin from the top of the internal cylinder and then remove the cylinder from the machine.
5. Loosen the bolt from the lower right side of the frame.
6. Remove the lock nuts from securing bolts at the top of the slide plate.
7. Remove the socket head screws at the top of the dual slide from both sides of the assembly.
8. Install 3/8-16x5” bolts in the holes that socket head screws were removed from to use as lifting handles.
9. Lift the frame out of the machine.
LEAK MAINTENANCE
All fittings on this machine are O-ring style.
1. Disconnect machine from power.
2. If a leak is detected, tighten fitting with the proper wrench size. DO NOT over tighten. Over tightening could
damage O-rings.
3. If a leak still persists, remove fitting and replace O-ring.
WHEEL MOTOR CHANGE OUT
1. Disconnect machine from power.
2. Block up machine to remove wheel. See wheel changing on page 48.
3. Remove wheel.
4. Remove oil lines from wheel motor. A small amount of oil will run out of the lines. Drain into a container. Wipe up
spills immediately.
5. Remove four 1/2" wheel motor securing nuts.
6. Pull out on wheel motor to remove.
HOSE CHANGE OUT
To Remove Or Change A Hose
1. Disconnect machine from power.
2. Remove hood.
3. Using proper wrench size, remove hose from fitting.
4. When replacing, make sure O-ring is properly seated on hose fitting.
3. Remove bolt and foot peg.
4. Replace foot peg before operating machine. DO NOT use machine without foot pegs.
Содержание All Day Battery Ride-On 7700
