![background image](http://html1.mh-extra.com/html/national/all-day-battery-ride-on-7700/all-day-battery-ride-on-7700_instruction-manual_3373489029.webp)
Page 29
7700 LOADING/UNLOADING
• Always remove blade and cutting head when machine is being moved or transported
• Cutting head and slide plate can be removed to make the machine more compact.
• NEVER leave machine unattended on an incline.
• Removing added weights help to make the machine easier and safer to move in and out of a vehicle.
DOCK HEIGHTS
It is best to load or unload the machine from a level/equal dock height (a van from a van dock height, a
truck/semi from a regular dock height).
POWER-GATE
A power-gate can be used when the dock height is not available. Make sure gate is properly rated for
3,000 lbs. / 1,360 kgs. Make certain the machine is secure so it does not roll off the power-gate. To better
secure machine, raise machine onto the lowered cutting head, raising machine off the caster. Tie
machine down, chock wheels.
RAMPS
To be safe, the ramp needs to be very long to accommodate the machine being loaded/unloaded.
Remove added weight. Make sure ramp is secured. Do not have at a steep incline. The use of a power
winch or hand come-a-long is much safer. For a van, the ramp should be 12 to18 feet / 3.5 to 5.5 meters
in length depending on the depth of the incline. For truck height taller than a van, longer ramps will be
needed. See OSHA guidelines. It is not recommended to drive the machine, connected with power, on a
ramp. Make sure ramp is secure and has good contact before using. Failure to do so could cause ramp
to fall away from the vehicle.
Note:
See correct and safe operating angles and center of gravity on page 31.
WARNING:
Machine has a swivel front caster.
Never
side hill (Figure A). The machine on a
incline without power, the front caster will cause machine to swing to the lowest point. If it is necessary
to run machine on an incline, run machine on cutting head. Place at least a 8'' cutting head in
machine. To keep from damaging floor, clamp a piece of carpet into cutting head to slide on the floor.
This will give positive contact with the floor when power is disengaged from the wheels.
Figure A
CAUTION: DO NOT “SIDEHILL”
CAUTION: MACHINE IS BACK HEAVY.
DO NOT RUN ON STEEP INCLINE--
THIS COULD CAUSE MACHINE TO TIP OVER!
Содержание All Day Battery Ride-On 7700
