Chapter 3
Configuration and Default Settings
©
National Instruments Corporation
3-15
To replace a fuse, do the following:
1.
Turn off the VXI mainframe and remove the VXIpc 870 Series
module.
2.
Using a small flathead screwdriver, turn the fuse holder
counter-clockwise until the fuse and holder start to come out of
the unit.
3.
Replace the fuse with the same type fuse.
Caution
Do
not
replace with a higher-rated fuse. This could cause damage to the
VXIpc 870, the VXI mainframe, or both.
4.
Insert the fuse and hold back into the fuse housing, pushing it all the
way in.
5.
Screw the fuse holder clockwise until the fuse holder is flush with the
fuse housing.
6.
Re-install the VXIpc 870 and apply power.
Note
If the fuse continues to blow, contact National Instruments for assistance.
