National Instruments USRP-2974, Руководство по началу работы, Страница: 10 / 18

Table 2. Ethernet Port Addressing
Ethernet Port
Addressing
Port Description
eth0
1G ETH RJ45
eth1
Internal 10G ETH
eth2
External SFP+ 1G/10G ETH 0
Note The external SFP+ 1G/10G ETH 1 port does
not have access to the system on module (SoM).
5. Set the mode.
6. Set the address if the mode is static.
7. Click Apply .
How Do I Change My IP Address without Using My Computer?
1. Connect the USRP-2974 to a monitor, keyboard, and mouse.
2. Enter your login credentials.
3. Use the Linux command
ifconfig <Port> <IP Address>
, where
<Port>
is one
of the following Ethernet ports, and
<IP Address>
is the new IP address.
Table 3. Ethernet Port Addressing
Ethernet Port
Addressing
Port Description
eth0
1G ETH RJ45
eth1
Internal 10G ETH
eth2
External SFP+ 1G/10G ETH 0
Note The external SFP+ 1G/10G ETH 1 port does
not have access to the system on module (SoM).
For example, if you would like to change the IP address of the 1G ETH RJ45 port, use the
Linux command
ifconfig eth0 <IP Address>
.
Notice This change is lost once the device is turned off. Once the device is
accessible from your computer, change the IP address using your computer as
described in
How Do I Change My IP Address Using My Computer? to ensure the IP
address is set indefinitely.
Why Does the Device Not Connect to the Host Interface?
Ensure the connection between the host network interface card and the device cable
connection is valid and both the device and computer are powered on.
10 | ni.com | USRP-2974 Getting Started Guide