©
National Instruments Corporation
7
TBX-1328 Installation Guide
Figure 4.
The Completed Installation
Rack Mounting
When you have completed the
Installing the Terminal Block and Cable
Assembly
section, you can mount the TBX assembly in the rack. If you are
using the National Instruments TBX Rack-Mount Assembly, refer to the
TBX Rack-Mount Installation Guide
for instructions.
If you are not using this rack-mount assembly, complete the following steps
to mount the TBX assembly directly onto the DIN rail:
1.
Snap the TBX terminal block onto the DIN rail with a firm push.
2.
Install the SCXI chassis using the appropriate chassis rack-mount kit.
Note
To remove the TBX terminal block from the DIN rail, place a flathead screwdriver
into the slot above the terminal block base and pry it from the rail.
5
4
3
2
1
ADDRESS