©
National Instruments Corporation
B-1
B
Removing the SCXI-1521/B
This appendix explains how to remove the SCXI-1521/B from MAX and
an SCXI or PXI/SCXI combination chassis.
Removing the SCXI-1521/B from MAX
To remove a module from MAX, complete the following steps after
launching MAX:
1.
Display the list of installed devices and interfaces by clicking
the
+
next to the
Devices and Interfaces
icon.
2.
Click the
+
next to
NI-DAQmx
Devices
to display the chassis.
3.
Click the
+
next to the appropriate chassis to display the installed
modules.
4.
Right-click the module or chassis you want to delete and click
Delete
.
5.
You are presented with a confirmation window. Click
Yes
to continue
deleting the module or chassis or
No
to cancel this action.
Note
Deleting the SCXI chassis deletes all modules in the chassis. All configuration
information for these modules is also lost.
The SCXI chassis and/or SCXI module(s) should now be removed from the
list of installed devices in MAX.
Removing the SCXI-1521/B from a Chassis
Consult the documentation for the chassis and accessories for additional
instructions and precautions. To remove the SCXI-1521/B module from a
chassis, complete the following steps while referring to Figure B-1:
Note
Figure B-1 shows an SCXI chassis, but the same steps are applicable to a PXI/SCXI
combination chassis.
1.
Power off the chassis. Do
not
remove the SCXI-1521/B module from
a chassis that is powered on.
2.
If the SCXI-1521/B is the module cabled to the E/M Series DAQ
device, disconnect the cable.
