Chapter 1
About the SCXI-1502
SCXI-1502 User Manual
1-4
ni.com
Installing Application Software, NI-DAQ, and the
DAQ Device
Refer to the
DAQ Getting Started Guide
packaged with the NI-DAQ
software to install your application software, NI-DAQ driver software, and
the E/M Series DAQ device to which you will connect the SCXI-1502.
NI-DAQ 8.1 or later is required to configure and program the SCXI-1502
module. If you do not have NI-DAQ 8.1 or later, you can either contact a
NI sales representative to request it on a CD or download the latest
NI-DAQ version from
ni.com
.
Note
Refer to the
Read Me First: Safety and Radio-Frequency Interference
document
before removing equipment covers or connecting or disconnecting any signal wires.
Installing the SCXI-1502 into an SCXI Chassis or a PXI/SCXI
Combination Chassis
Refer to the
SCXI Quick Start Guide
to install the SCXI-1502 module.
Installing the Terminal Block
Table 1-1 shows the supported SCXI-1502 terminal blocks. Refer to the
SCXI Quick Start Guide
and the terminal block installation guide for more
information about the terminal block.
Table 1-1.
Supported SCXI-1502 Terminal Blocks
Terminal Block
CJC Sensor
Measurement Type
SCXI-1303
Yes
Thermocouple
measurements
TBX-1303
Yes
TC-2095
Yes
SCXI-1300
Yes
Voltage, RTD
TBX-96
No
SCXI-1310
No
SCXI-1308
No
Current