National Instruments SCXI-1194, Руководство по началу работы

Страница: 14 / 23

8. Screw the switch front panel to the chassis front panel mounting rail.
9. Power on the chassis.
Related Information
Refer to the Read Me First: NI-DAQmx and DAQ Device Installation Guide if you are
installing an NI PXI/PCI M Series device.
Refer to the NI Digital Multimeters Getting Started Guide if you are installing an NI 407x.
Installation Procedure 4
Connect an NI USB switch controller/adapter directly to an NI SCXI switch module with a 10-
pin rear connector.
Refer to the following figure and complete the following steps to install an NI SCXI switch
module and cable it to an NI USB switch controller
Figure 7. Cabling an NI USB Switch Controller to a 10-Pin Rear Connector Switch Module
or
1
3
2
7
6
4
5
1. NI SCXI Switch Module
2. HVAB Connector
3. 10-Pin Rear Connector
4. USB Cable 5. NI Switch Controller
6. NI 1359 Cable Adapter
7. NI SCXI-1000/1001 or NI PXI-1010/1050 Chassis
1. Power off and unplug the chassis.
NI Switches Getting Started Guide | © National Instruments | 13