Chapter 1
Installing and Configuring the SCXI-119X
1-12
www.ni.com
Removing the SCXI-119
X
This section describes how to remove the SCXI-119X from an SCXI
chassis.
Removing the SCXI-119
X
from an SCXI Chassis
Make sure you read and understand all the safety information in this
manual before you remove an SCXI module. You need the following items
to complete this task:
•
SCXI chassis with the SCXI-119X module(s) installed
•
1/4 in. flathead screwdriver
Consult the documentation for your SCXI or PXI (if you are using a
combination chassis) chassis and accessories for additional instructions
and warnings. To remove the SCXI-119X module from an SCXI chassis,
follow these steps while referring to Figure 1-3:
1.
Remove all signals connected to the SCXI-119X.
2.
Turn off the SCXI chassis power.
Caution
Do not remove the SCXI-119X module from a chassis that is turned on as doing
so could damage the module.
3.
Rotate the thumbscrews securing the SCXI-119X to the chassis
counter-clockwise until they are loose, but do not completely remove
the thumbscrews.
4.
Remove the SCXI-119X by pulling steadily on both thumbscrews until
the module slides completely out.
