SCXI-1181K Custom Module Assembly Install. Guide
2
© National Instruments Corporation
Refer to the reference numbers of the components in the previous table and the corresponding
components in Figure 1 for module assembly.
Note: The four P1 connectors have a push-fit peg. Secure the P1 connectors to the printed
wire circuit board (PWB) by pushing the connector onto the PWB so that the middle
peg of the connector presses into the 0.081 in. hole in the PWB. National Instruments
recommends using the push-fit peg hand tool (part number CTHT-200) manufactured
by ITT Cannon for this installation. You can contact ITT Cannon at (800) 845-7000.
Figure 2 shows the SCXI module PWB outline.
