National Instruments SCXI-1129, Руководство пользователя

Страница: 32 / 82

Chapter 1 Installing and Configuring the SCXI-1129
SCXI-1129 User Manual 1-24 ni.com
Manually Adding Modules
If you selected not to auto-detect your SCXI modules, you must add each
of your modules separately.
1. Click Finish in the SCXI Auto-Detect window.
2. Expand Devices and Interfaces . You will see the chassis you selected
in the list.
3. Expand Chassis .
4. Right-click the slot that is cabled to your device and select Insert . For
DAQ devices this is the slot cabled to the DAQ device. For DMMs, this
is typically slot 4, on 4-slot chassis, and slot 12 on 12-slot chassis,
based on the installation instructions in earlier sections used to
configure the chassis.
5. Select the module that is intended for that slot and click Next .
6. You are now given the option to make this the module that controls the
chassis. Select the DAQ device or DMM you cabled to the chassis
using the
Connected to: control. Confirm that there is a check in the
checkbox labeled This device will control the chassis and click Next .
7. You are presented with a series of properties for the module. Select the
appropriate values for the attributes and click
Next . After making your
selections, click Finish .
You are now finished configuring the slot. Configure the rest of your
modules in the same manner.
To remove a module or chassis, right-click the chassis or module you want
to remove and select
Delete .
To test the chassis configuration, right-click the chassis and select Test .