![background image](http://html1.mh-extra.com/html/national-instruments/sc-2345-carrier/sc-2345-carrier_user-manual_3630080009.webp)
Chapter 1
Setting up the SC-2345/2350 Carrier
SC-2345/2350 Carrier User Manual
1-2
ni.com
•
SC-2345 carrier with configurable connectors and a rear cable
connector
•
SC-2345 carrier with configurable connectors and a side cable
connector
Note
Refer to Figure 1-9 and the
SCC Quick Start Guide
for more information about all
these carrier forms.
SC-2350 Carrier
The SC-2350 carrier supports analog I/O SCC modules. The SC-2350
carrier supports reading from and writing to Transducer Electronic Data
Sheet (TEDS) Class II sensors for its analog input SCC modules. The
SC-2350 carrier is available with configurable connectors and a side cable
connector. Refer to Figure 1-9
and the
SCC Quick Start Guide
for more
information.
What You Need to Get Started
To set up and use the SC-2345/2350 carrier, you need the following items:
❑
Hardware
–
SC-2345/2350 carrier with one of the following factory-installed
power modules:
•
SCC-PWR01
•
SCC-PWR02 and the PS01 power supply
•
SCC-PWR03 (requires a 7 to 42 VDC power supply,
not included)
–
68-pin E/M Series DAQ device with a shielded 68-pin cable of
less than 2 m length
or
–
100-pin E Series DAQ device with an SH1006868 cable
(to connect 100-pin devices to two 68-pin connectors)
–
One or more SCC modules
–
Rack-mount or stack-mount kit (optional)
–
One or more I/O panelettes
Note
You cannot use the I/O panelettes on the SC-2345 carrier with connector block.