![background image](http://html1.mh-extra.com/html/national-instruments/sc-2345-carrier/sc-2345-carrier_user-manual_3630080024.webp)
Chapter 1
Setting up the SC-2345/2350 Carrier
©
National Instruments Corporation
1-17
SC-2345/2350 Carrier User Manual
SCC-PWR01
The SCC-PWR01 co5 V to ±15 V, which is the analog power
supply that SCC modules use. Set switch S1 on the SCC-PWR01 to select
the source of the +5 V as either
E SER
(E/M Series) or
EXT
(external). If
you select
E SER
, the SCC-PWR01 uses +5 V power from the E/M Series
DAQ device. If you select
EXT
, you must connect a +5 V supply (user
supplied) to the screw terminals of J1 on the SCC-PWR01. Wire the
positive lead to the screw terminal labeled
+
5 V
and wire the negative lead
to the screw terminal labeled
GND
. If you are using the SC-2345 carrier,
pass the leads through the strain relief on the front of the enclosure. If you
are using an SC-2345/2350 with configurable connectors, use a strain-relief
panelette for the leads.
Figure 1-10.
Using the SCC-PWR01
1
SC-2345/2350 Carrier
2
5 VDC Power Supply (User-Supplied, Optional)
3
DAQ Device
4
J24
5
Positive Lead to +5 V Screw Terminal
on SCC-PWR01 Connector J1
6
Negative Lead to GND Screw Terminal
on SCC-PWR01 Connector J1
4
5
1
3
2