![background image](http://html1.mh-extra.com/html/national-instruments/sc-2345-carrier/sc-2345-carrier_user-manual_3630080013.webp)
Chapter 1
Setting up the SC-2345/2350 Carrier
SC-2345/2350 Carrier User Manual
1-6
ni.com
e.
For each SCC module physically installed in the SC-2345 carrier,
add a corresponding entry in the SC-2345 Connector Block
Configuration window. Click the drop-down listbox and select the
correct module. If the module name does not appear in the list,
either the module is not allowed in that location or you do not have
NI-DAQ 7.4 or later. If you do not have the current version of
NI-DAQ, download it from
ni.com/downloads
.
5.
Click
OK
after completing all SCC module entries.
6.
Click
OK
to complete the configuration process and close MAX.
You have completed the steps to configure the SC-2345 carrier as an
E/M Series DAQ device accessory.
Note
Configuring the SCC system using MAX automatically sets the E/M Series DAQ
device analog input mode to NRSE. If you are configuring digital SCC modules, the
configuration automatically sets individual digital lines to the appropriate direction, input
or output.
Configuring the SC-2350 Carrier as a DAQ Accessory
Complete the following steps to run MAX and configure the SCC system:
1.
Open MAX.
2.
Right-click
Devices and Interfaces
and select
Create New
.
3.
Under NI-DAQmx SCC Connector Block, select
SC-2350
.