2-18
|
ni.com
Chapter 2
Installation and BIOS Setup
Removable Drives
Use this option to specify the removable drive boot sequence. The settings are
1st boot device
,
2nd boot device
, and
Disabled
.
•
1st drive
•
2nd drive
: [USB: XXXXXXXXX]
Retry Boot Devices
Select this option to retry booting from the configured boot devices if the systems fail to boot
initially. The options are
Disabled
and
Enabled
.
Exit Options
Select the
Exit
tab from the AMI BIOS Setup Utility screen to enter the Exit BIOS Setup screen.
Save Changes and Exit
When you have completed the system configuration changes, select this option to leave the
BIOS Setup Utility and reboot the computer so the new system configuration parameters can
take effect. Select
Save Changes and Exit
from the
Exit
menu and press <Enter>.
Discard Changes and Exit
Select this option to quit the BIOS Setup Utility without making any permanent changes to the
system configuration and reboot the computer. Select
Discard Changes and Exit
from the
Exit
menu and press <Enter>.
Discard Changes
Select this option and press <Enter> to discard all changes and return to the AMI BIOS Setup
Utility.
Load Optimal Defaults
To set this option, select
Load Optimal Defaults
from the
Exit
menu and press <Enter>. Then
select
OK
to allow the AMI BIOS to load optimal defaults to the BIOS settings automatically.
The optimal settings are for maximum system performance, but may not work best for all
computer applications.
Load Fail-Safe Defaults
To set this option, select
Load Fail-Safe Defaults
from the
Exit
menu and press <Enter>. The
fail-safe settings are for maximum system stability, but not for maximum performance.
POST Error Beep Codes
This section lists Power On Self Test (POST) error beep codes for the AMI BIOS. POST error
beep codes are in two categories: recoverable and terminal. This section lists beep codes for
recoverable POST errors.
