11. Power on the chassis.
Note
The first time you start the development computer after installing the
hardware, allow several seconds for the drivers to load.
Confirming the Device is Recognized
To confirm that the device is properly installed and the hardware is recognized, complete the
following steps:
1.
Select
Start
»
All Programs
»
National Instruments
»
Measurement & Automation
Explorer
to open Measurement & Automation Explorer (MAX).
2.
Verify that the camera connected to the PXIe-8246 appears under
My System
»
Devices
and Interfaces
»
NI-IMAQdx Devices
.
Front Panel
The following figure shows the PXIe-8246 front panel.
Figure 2. PXIe-8246 Front Panel
PXIe-8246
Image Acquisition
0
1
2
3
PoE
0
1
2
3
PXIe-8246 Getting Started Guide
|
© National Instruments Corporation
|
5