Chapter 2
Installation and Configuration
2-18
ni.com
As an alternative to a USB CD-ROM drive, you can use an external SCSI
CD-ROM with a PXI-SCSI adapter.
Note
For additional assistance with installing or changing an operating system, refer to
KnowledgeBase 2ZKC02OK at
ni.com/support
.
ExpressCard
This section provides information on the installation and removal of
ExpressCard modules.
Installing an ExpressCard
You can install an ExpressCard module while the NI PXI-8105 is running.
The NI PXI-8105 will automatically detect the card. ExpressCards are
generally marked with a symbol or a label to indicate which end to insert
into the slot. The cards are keyed to prevent incorrect insertion.
To install an ExpressCard, complete the following steps.
1.
Hold the card so the top side is facing left.
2.
Insert the card until it is completely seated in its connector. The
connector has an automatic eject mechanism. If you insert the card and
it is ejected, simply re-insert the card until it is seated.
If you encounter too much resistance, do not force the card. Check the card
orientation and try again.
The PXI-8105 will automatically recognize the ExpressCard and load the
appropriate driver(s). Third-party cards may require that you install
additional drivers. Contact your ExpressCard vendor for more information.
Caution
The ExpressCard interface is ESD sensitive. An electrostatic shock on the
ExpressCard module while it is inserted may cause the controller to lock-up or reboot.
Removing an ExpressCard
To remove the ExpressCard module push in the module and then release to
eject the card. Slide the card out of the slot.
Caution
To avoid data loss and other potential issues, stop communication with your
ExpressCard device before removing it from the PXI-8105. In Windows, use the Safely
Remove Hardware tool to safely stop the ExpressCard.
