![background image](http://html1.mh-extra.com/html/national-instruments/pcie-5775/pcie-5775_getting-started-manual_710028004.webp)
Indoor use only.
Note
For complete specifications, refer to the specifications document for your
.
Installing the Software and Driver
Before installing your hardware, you must install the application software and instrument
driver. Visit
NI FlexRIO Driver Supported Versions for FlexRIO Adapters and Modules
determine which minimum software versions you need for your device. Install the software in
the following order:
1.
Install LabVIEW.
Refer to the
LabVIEW Installation Guide
for installation instructions for LabVIEW and
system requirements for the LabVIEW software. Refer to the
LabVIEW Upgrade Notes
for additional information about upgrading to the most recent version of LabVIEW for
Windows. Documentation for LabVIEW is available at
.
2.
Install the LabVIEW FPGA Module.
Refer to the
LabVIEW FPGA Module Release and Upgrade Notes
for installation
instructions and information about getting started with the LabVIEW FPGA Module.
Documentation for the LabVIEW FPGA Module is available at
.
3.
(Optional) Install the LabVIEW Real-Time Module.
Refer to the
LabVIEW Real-Time Module Release and Upgrade Notes
for system
requirements, installation instructions, and additional information about using the
LabVIEW Real-Time Module.
4.
Install FlexRIO.
Refer to the
FlexRIO Readme
for system requirements and installation instructions for
FlexRIO. Documentation for FlexRIO is available at
.
Installing the PCIe-5775
1.
Power off and unplug the computer.
2.
Access the computer system expansion slots. This step might require you to remove one
or more access panels on the computer case.
3.
Locate a compatible slot and remove the corresponding slot cover on the computer back
panel.
4.
Touch any metal part of the computer to discharge any static electricity.
5.
Insert the module into the slot you selected. Gently rock the module in to place without
forcing it.
4
|
ni.com
|
PCIe-5775 Getting Started Guide