©
National Instruments Corporation
2-1
2
PCI-7041 Installation and
Configuration
This chapter contains instructions for installing and configuring the
PCI-7041.
Caution
Electrostatic discharge can damage several components on the PCI-7041. To
avoid such damage in handling the board, touch the antistatic plastic package to a metal
part of your computer before removing the module from the package.
Note
Install LabVIEW Real-Time (RT) and NI-DAQ before you install the PCI-7041.
Refer to Chapter 2,
Installation
, of the
LabVIEW Real-Time User Manual
for information
about installing LabVIEW RT and NI-DAQ.
PCI Installation
Complete the following steps to install the PCI-7041.
1.
Power off and unplug your computer.
2.
Remove the computer cover.
3.
Make sure there are no lit LEDs on the motherboard. If any are lit,
wait until they go out before continuing the installation.
4.
Remove the expansion slot cover on the back panel of the computer.
5.
Insert the PCI-7041 into a 5 V or 3.3 V PCI slot. Gently rock the board
to ease it into place. It might be a tight fit, but do not force the board
into place.
6.
Screw the mounting bracket of the PCI-7041 to the back panel rail of
the computer.
7.
Install the accessory board according to the
section (optional).
8.
Visually verify the installation. Make sure the boards are not touching
other boards or components and are fully inserted in the slots.
9.
Replace the cover.
10. Plug in and power on your computer.
