![background image](http://html2.mh-extra.com/html/national-instruments/ni-pxie-4080/ni-pxie-4080_calibration-procedure_3559529014.webp)
DMM Settings
Calibrator Settings
Tolerances
As-Found
As-Left
Range OCO Resistance
Ext
Sense
Comp
ppm of
Reading
ppm of
Range
ppm of
Reading
ppm of
Range
10 kΩ
Off
10 kΩ
On
2-Wire 80
23
12
22
1 kΩ
Off
1 kΩ
On
2-Wire 80
203
12
202
100 Ω
Off
100 Ω
On
2-Wire 80
2015
15
2010
You have completed verifying the 2-wire resistance mode of the PXIe-4080/4082. Select one
of the following options:
•
If you want to continue verifying other modes, go to the
Verifying DC Current
section.
•
If you are performing a pre-adjustment verification, close the session.
•
If you do not want to verify any additional modes, and you want to update the verification
time stamp, complete the following steps:
1.
Open a new calibration session to the instrument (with correct calibration password).
2.
Close the calibration session with the
Action
set to
Save
.
Verifying DC Current
Complete the following steps to verify DC current:
1.
Unplug all cables from the PXIe-4080/4082.
2.
Reset the PXIe-4080/4082.
3.
Initialize the PXIe-4080/4082 for DC current with a range of 20 mA and resolution of 6.5
digits.
4.
Verify the accuracy for each configuration in the following table:
a)
Acquire the measurement at each specified range.
b)
Compare to the specified limits.
DMM Range
As-Found Limits
As-Left Limits
Lower
Upper
Lower
Upper
20 mA
-4.00 µA
4.00 µA
-0.30 µA
0.30 µA
200 mA
-4.0 µA
4.0 µA
-3.0 µA
3.0 µA
1 A
-50 µA
50 µA
-15 µA
15 µA
5.
Set the calibrator to
Standby
.
6.
Connect the PXIe-4080/4082 to the calibrator using low leakage cables according to the
configuration in the following figure.
14
|
ni.com
|
PXIe-4080/4082 Calibration Procedure