National Instruments NI EDIDS-2400 Series, Руководство пользователя, Страница: 165 / 314

NI EDIDS-2400 Series User Manual | © National Instruments | 165
Tip Strip: Specifies the period length, in number of cycles, for the skip fire sequence in EPT Mode (Min = 1).
Detail: Specifies the number of cycles included in a skip fire sequence when the PFI injector is operated in EPT
mode. For example, if the number 7 is entered, the PFI injector will continuously repeat a seven cycle sequence as
long as SkipFire_PFI_ChnX is enabled for the desired channel.
PFI1_SkipFire_OnCycle
Tip Strip: Specifies the number of active cycles during skip fire sequence in EPT Mode (Min = 1).
Detail: Specifies the number of active cycles included in a Skip Fire Sequence when the DI injector is operated
in EPT mode. For example, if the number 4 is entered and PFI SkipFire_Cycles is set to 7, the PFI injector
will continuously repeat a seven cycle sequence with four active cycles, followed by three inactive cycles as
long as SkipFire_PFI_ChnX is enabled for the desired channel. It is also manipulated by the corresponding
SkipFire_OnCycle control in all the PFI Advanced Settings windows.
TMP Pulse Enable
Tip Strip: Enables injection pulse
Detail: When ON , the TMP Mode command to the PFI Driver module will be active for the specified duration. When
OFF
, the command will be inactive, but the specified timing and duration will still be implemented. Therefore, the
timing of the adjacent pulses will remain the same whether the pulse is ON or OFF
Delay
Tip Strip: Time until beginning of this injection pulse
Units: msec
Detail: Specifies the delay of the start of injection from the trigger event.
Duration Ch1
Tip Strip: Duration of injection pulse
Units: msec
Detail: Time duration of the TMP Mode injection pulse. The ON/OFF button above each Delay and Duration
parameter determines whether the pulse will be active or inactive.
Duration Ch2-4