©
National Instruments Corporation
19
NI Switches Getting Started Guide
2.
Configure the module properties.
•
(Optional) Select the terminal block/accessory from the
Terminal Block/Accessory
list box.
•
Set the default topology of the switch module by selecting
a topology from the
Topology
list box.
3.
Click
OK
to accept the changes.
4.
You can perform a self-test on switches listed under NI-DAQmx
Devices. Right-click the switch you want to test.
5.
Select
Self-Test
to test the selected device.
6.
When the self-test finishes, a message indicates if an error occurred.
If an error occurs, refer to
ni.com/support/install
for
troubleshooting information.
PXI System
1.
Right-click the switch name and select
Properties
. Be sure to click the
device name under PXI System.
Note
Only the PXI-2501/2503/2565/2590 and PXI-2591 can be configured under
PXI System.
Figure 12.
Configuring Switch Modules Under PXI System in MAX
