NI Digital Waveform Generator/Analyzer Guide
14
ni.com
7. Connecting Signals
This section discusses what connections you can make to the device, and how
to connect signals to the device for performing dynamic acquisition and
dynamic generation. For device front panel diagrams and connector
descriptions, refer to
Appendix A: Device Front Panels
Connecting Cables and Accessories
To make connections to the NI digital waveform generator/analyzer
front
panel SMB jack connectors, use a shielded 50
Ω
coaxial cable with an SMB
plug end.
Use an NI SHC68-C68-D2 cable for connections to the NI 654
X
/655
X
DDC
connector. The NI SHC68-C68-D2 is designed for single-ended, high-speed
digital signal transmission. The cable is shielded, with individual
microcoaxial 50
Ω
lines for each signal. Use an SHB12X-B12X cable for
connections to the NI 656
X
DDC connector. This cable is designed for
differential, high-speed digital signal transmission.
Using Accessories (NI 654
X
/655
X
Only)
NI recommends using the NI CB-2162 single-ended digital I/O accessory to
access the signals on the 68-pin DDC connector and to terminate the
DIO channels. The NI CB-2162 also provides a platform for circuit
prototyping and DUT testing. The NI CB-2162 is specifically designed for
use with single-ended NI digital waveform generator/analyzers
(NI 654
X
/655
X
). For more information about using the NI CB-2162, refer to
the
NI CB-2162 User Guide
.
NI also offers the NI SMB-2163 breakout box for National Instruments
single-ended digital waveform generator/analyzers. The NI SMB-2163 offers
coaxial SMB connectors for each channel on the DDC connector, providing
an easy way to connect to other devices for testing and debugging. For more
information about using the NI SMB-2163, refer to the
NI SMB-2163 User
Guide
.
Figures 4 and 5 show how to connect a single-ended NI digital waveform
generator/analyzer and the NI CB-2162 and NI SMB-2163, respectively,
using the NI SHC68-C68-D2 cable.
