© National Instruments
|
5-1
5
Cables and Accessories
National Instruments offers the following products for use with NI 651
x
devices.
Caution
For compliance with Electromagnetic Compatibility (EMC)
requirements, this product must be operated with shielded cables and accessories. If
unshielded cables or accessories are used, the EMC specifications are no longer
guaranteed unless all unshielded cables and/or accessories are installed in a shielded
enclosure with properly designed and shielded input/output ports.
Accessories for 37-Pin Devices
National Instruments offers the following connectivity options for use with 37-pin safety low
voltage (
60 V DC/42.4 V peak/30 V RMS) NI 6510/6516/6517/6518/6519 devices.
Choose from the following screw terminal connectivity options:
•
CB-37F Connector Block—part number 778672-01 (vertical) and 778673-01 (horizontal)
•
CB-37F-LP Unshielded, I/O Connector Block with 37-Pin D-SUB—part number
779353-01
With one of the following cabling options:
–
SH37F-37M Shielded Cable—part number 778621-01 (1 m) and 778621-02 (2 m)
–
SH37F-P-4 37-Pin Female-to-Pigtails Shielded I/O Cable—part number 778620-04
(4 m)
–
R37F-37M-1 37-Pin Female-to-Male Ribbon I/O Cable—part number 779195-01
(1 m)
You may also choose from the following custom connectivity options:
•
SH37F-P-4 37-Pin Female-to-Pigtails Shielded I/O Cable—part number 778620-04 (4 m)
•
TB-37F-37CP 37-Pin Crimp & Poke Terminals, Shell with Strain Relief—part number
779185-01
•
TB-37F-37SC 37-Pin Solder Cup Terminals, Shell with Strain Relief—part number
779184-01
For more information about optional equipment available from National Instruments, refer to the
National Instruments catalog or visit the National Instruments Web site at
ni.com
.