Figure 5. Typical Proximity Probe Power and Signal Wiring (MON-10467 (AC) and
MON-10467 (DC) only)
MON-10467 (AC),
MON-10467 (DC)
AI<a>–
AI<a>+
AI<b>–
V
C
AI<b>+
Typical Proximity Probe Drivers
(Case isolated from Power and Signal)
COM
Signal OUT
COM
24
VDC
–24 VDC
COM
Signal OUT
COM
–24 VDC
+
–
Note
Ensure that you are wiring in the correct orientation. The MON-10467 is
powered by a positive-polarity DC supply voltage, whereas many proximity probe
drivers are powered by a negative-polarity DC supply voltage.
Wiring
Wiring Guidelines
Adhere to the following guidelines when wiring the MON-10467.
Caution
All wiring must be insulated for the highest voltage used.
Attention
Tout le câblage doit être isolé pour la plus haute tension utilisée.
Caution
Disconnect external power to the MON-10467 (AC) and use the external
circuit breaker box to completely remove mains power before opening the device for
service.
Attention
Débranchez l'alimentation externe du MON-10467 (AC) et utilisez le
boîtier de disjoncteur externe pour couper complètement l'alimentation secteur avant
d'ouvrir l'appareil pour l'entretien.
Caution
Remove power to the MON-10467 (DC) before opening it for service.
18
|
ni.com
|
MON-10467 User Guide