©
National Instruments Corporation
3
SCC-AO10 Isolated Analog Output Module User Guide
Note
Software scaling of measurements is not supported on the Macintosh operating
system. Refer to the
SCC-AO10 Connector Pin Assignments
section.
You can download NI documents from
ni.com/manuals
. To download
the latest version of NI-DAQmx, click
Download Software
at
ni.com
.
Device Specific Information
Note
For general SCC module installation and signal connection information, and
information about the SC-2345/2350 carrier, refer to the
SCC Quick Start Guide
, available
for download at
ni.com/manuals
.
Installing the SCC-AO10
Caution
Refer to the
Read Me First: Safety and Radio-Frequency Interference
document
before removing equipment covers or connecting/disconnecting any signal wires.
Plug the SCC-AO10 into either SC-2345/2350 analog output socket
J(
X
+
17), where
X
is 0 or 1. The SC-2345/2350 routes the voltage output of
E/M Series DAQ device analog output channel AO (
X
) to the SCC-AO10.
Connecting the SCC-AO10 to a Load
Caution
Refer to the
Read Me First: Safety and Radio-Frequency Interference
document
before removing equipment covers or connecting/disconnecting any signal wires.
Note
The signal names have changed. Refer to
ni.com/info
and enter
rdtntg
to
confirm the signal names.
The SCC-AO10 has a three-pin screw-terminal connector that accepts
28 to 16 AWG wires.
The screw terminals are labeled by pin numbers 1 to 3. Pin 1 is the isolated
ground. Pins 2 and 3 both connect to the isolated voltage output for
flexibility in field wiring.
Caution
Connecting an external voltage source to the output terminals of the SCC-AO10
may damage the module.
