Appendix B
Using the DMAmove and CDS-852 Adapter Code Instruments
B-4
ni.com
For example, to install the single DMAmove CI and two 852 adapter CIs and enable debug
statement printing on the second 852 CI, enter the following sequence, which has been
highlighted in boldface type for this example:
----- Resident CI Base Location Configuration -----
Enter Number of Base Location to EDIT (0xff = EXIT):
0
Enter Address for Base 0x01 (default = 0x000000):
F7C000
Debug mode ON for Resident CI 0x01 (default NO):
N
Enter Number of Base Location to EDIT (0xff = EXIT):
4
Enter Address for Base 0x00 (default = 0x000000):
F7E000
Debug mode ON for Resident CI 0x00 (default NO):
<CR>
Enter Number of Base Location to EDIT (0xff = EXIT):
5
Enter Address for Base 0x01 (default = 0x000000):
F7E000
Debug mode ON for Resident CI 0x01 (default NO):
Y
Enter Number of Base Location to EDIT (0xff = EXIT):
<CR>
When the edit menu reappears, enter
Q
to exit the configuration editor. When the Nonvolatile
Configuration main menu appears, enter
5
to save the configuration changes. When the
Nonvolatile Configuration main menu reappears, enter
2
to confirm the configuration
information. The CI configuration for the previous example would be displayed as follows:
------ Resident Code Instrument Locations ------
0x00: 00F7C000 0x01: 00000000 0x02: 00000000
0x03: 00000000 0x04: 00F7E000 0x05: 00F7E000
0x06: 00000000 0x07: 00000000 0x08: 00000000
0x09: 00000000 0x0A: 00000000 0x0B: 00000000
When the main menu reappears, enter
6
to quit the configuration mode. The following
message appears:
Must Re-initialize pROBE or reboot for pSOS changes to take effect.
Other changes made automatically when configuration saved.
DONE WITH CONFIGURATION
Change startup mode Dip settings to enter
different mode or push RESET to reconfigure.
**********************************************
**********************************************
*
*
*
*
*
*
*
*
*
*
