©
National Instruments Corporation
2-1
2
Install Your Hardware
This chapter describes how to install your GPIB-1284CT.
Step 1. Verify the Voltage Requirement
Make sure that the voltage marked on your GPIB-1284CT or on the power
supply matches the voltage that is supplied in your area.
Caution
Do not operate your GPIB-1284CT at any voltage other than the one marked on
your GPIB-1284CT or on the power supply. Doing so could damage the unit. Replacement
fuses for the AC version must be the proper type and size. For fuse specifications, refer to
Appendix C,
Step 2. Connect the Cables
To connect the cables to your GPIB-1284CT, complete the following steps:
1.
Connect the parallel cable, as follows:
a.
Make sure that the parallel cable is shielded and 2 m or less in
length.
b.
Connect the cable to your GPIB-1284CT 25-pin D-Sub connector
labeled COMPUTER.
c.
Securely fasten the holding screws.
d.
Connect the other end of the cable to the parallel port on your
computer.
2.
Connect the GPIB cable, as follows:
a.
Make sure that the GPIB cable is shielded and follow all IEEE 488
cabling restrictions.
b.
Connect the cable to your GPIB-1284CT 24-pin Champ connector
labeled GPIB.
c.
Tighten the thumb screws.
d.
Connect the other end of the cable to your GPIB device(s).