![background image](http://html1.mh-extra.com/html/national-instruments/foundation-ni-fbus/foundation-ni-fbus_hardware-and-software-user-manual_709117033.webp)
Chapter 3
Connector and Cabling
NI-FBUS Hardware and Software User Manual
3-2
ni.com
PCMCIA-FBUS
This section contains information about the pinout of the PCMCIA-FBUS
connectors.
Pinout Information
A PCMCIA-FBUS cable has been included in your kit. The following
figures show the pinout of the PCMCIA-FBUS connectors so you can
make your own cable if you need a longer cable than the one provided in
your kit.
Figure 3-2 shows the PCMCIA-FBUS cable. An arrow on the cable points
to pin 1 of the screw terminal block.
Figure 3-2.
PCMCIA-FBUS Cable
The PCMCIA-FBUS/2 cable has two Fieldbus connectors that are similar
to the one shown in Figure 3-2. The connector labeled
PCMCIA-FBUS,
PORT 1
is the connector for Fieldbus port 1 and the connector labeled
PCMCIA-FBUS, PORT 2
is the connector for Fieldbus port 2. Refer
to Figure 3-3 and Figure 3-4 for the pinouts of both connectors.
J2
J1
PCMCIA-FBUS, POR
T 1
V-
D-
SH
D+
V+