National Instruments FieldPoint FP-1300, Руководство пользователя

Страница: 23 / 53

Chapter 2 Installing and Configuring Hardware and Software
© National Instruments Corporation 2-11 FP-1300 User Manual
The following sections describe the functions of the DIP switch settings.
Figure 2-11. Overview of the FP-1300 DIP Switches
Configuring the Operating Mode
You can configure the FP-1300 to operate in user mode (USER) or
factory-default (DEF) mode using the
USER/DEF switch.
In user mode, the FP-1300 reads its baud rate and arbitration ID from the
configuration settings that were last saved in the FP-1300 software. To
configure the module for user mode, push the
USER/DEF switch to the
USER position.
Figure 2-12. USER/DEF Switch in User Mode
In factory-default mode, the FP-1300 baud rate is 500 Kbps and the
FP-1300 reads its base arbitration ID from the DIP switches on the module.
For more information about configuring base arbitration IDs using DIP
switches, refer to the
Configuring the Base Arbitration ID section. To
configure the FP-1300 to operate in factory-default mode, push the
USER/DEF switch to the DEF position.
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
Address
ID
Mode
Operating
Mode
1
0
1 2 3 4 5 6 7 8