Chapter 3
Ethernet Configuration
©
National Instruments Corporation
3-3
ENET-232 and ENET-485 Series User Manual
Select your serial device server and click
Properties...
for any of the
following reasons:
•
You need to configure an unconfigured IP address.
•
You need to change the current network parameters.
•
You previously used DHCP, but it is no longer available.
•
You are using DHCP and need to change the serial device server
hostname.
•
The
IP address/hostname
column displays an exclamation
point (
!
) next to your serial device server, indicating a
configuration problem. Refer to the
section for help resolving this problem.
•
You want to add or change a comment to help identify the device.
Click
Refresh
if you do not see your serial device server in the list of
Ethernet devices, or to discover a device that you recently added to the
network.
Click
Exit
(or
Cancel
) if you are using DHCP and you do not need to
change the hostname of the serial device server, or if you are finished
using NI Ethernet device configuration.
